6.2.1 Numeric Input/Display

Introduction

[Numeric Input/Display] displays the device's data or writes data to the device in a specified numeric format, and the data could be scaled.

Description

1) General

Read address: The data from designated address will be displayed.

Input: Enable input function and [Write Address] configuration;

Same read-write address: Configure [Write Address] is the same as [Read Address];

Write address: Write data to designated address. The address could be different [Read Address];

Keypad: it is standard numeric keypad, allow to input decimal and floating;

Note: Check it to use the comment information on the keyboard. When the user clicks on the part, the comment information will be written into the HUW1402 for display. The maximum length allowed for the comment is 63 characters;

2) Display

Font: It is located to font list; user could select font directly;

Input as "*": the data shown as "*";

Alignment: There are three modes;

Center: data display on the center of object;

Align left: data display on the left;

Align right: data display on the right;

3) Data format

Date: Select data format, below format could be supported;

Data format: Configure data display format;

Range: beyond the data range will be not inputted;

4) Keypad position

It is used for setting keypad position when input data;

5) Label

Configure label shown on the left/ right side of data;