11.22 Siemens S7-200 Smart (Ethernet)

Supported Series: Siemens S7-200 SMART Series Ethernet Module.

Website: http://www.siemens.com/entry/cc/en/

HMI Setting

Items	Settings	Note
Protocol	Simens S7-200 Smart Ethernet
Connection	Ethernet
Port No.	102
PLC station No.	2

Address list

Type	Device register	HMI register	Format	Range	Note
Bit
I	I	I ddddd.o	0.0~99999.7
Q	Q	Q ddddd.o	0.0~99999.7
V	VWbit	VWbit ddddd.o	0.0~99999.7
V	V	V ddddd.o	0.0~99999.7
M	M	M ddddd.o	0.0~99999.7
SM	SM	ddddd.o	0.0~99999.7
S	S	ddddd.o	0.0~99999.7	Read only
T	T	ddddd	0~99999	Timer state, read only
C	C	ddddd	0~99999	Counter state, read only
Word
I	IW	IW ddddd	0~99999
Q	QW	QW ddddd	0~99999
AI	AIW	AIW ddddd	0~99999
AQ	VB	VB ddddd	0~99999
V	VW	VW ddddd	0~99998	VW0=VB (0~1) VW2=VB (2~3) Address value is a multiple of 2
V	VD	VD ddddd	0~99998	VD0=VB (0~3) VD2=VB (4~7) Address value is a multiple of 4
M	MB	MB ddddd	0~99999
M	MW	MW ddddd	0~99999	MW0=MB(0~1) MW2=MB(2~3) Address value is a multiple of 2
M	MD	MD ddddd	0~99999	MD0=MB(0~3) MD4=MB(4~7) Address value is a multiple of 4
T	TW	TW ddddd	0~99999	Value of timer
C	CW	CW ddddd	0~99999	Value of counter
W	SW	SW ddddd	0~99999

Communication settings

7) Enable HMI Ethernet in [Project Settings];

8) Set PLC IP in [Device IP] settings;

 PLC IP Address: PLC IP

 PLC pot No.: 102(fixed)

 Network: TCP_Client_2N (fixed)

 Wait timeout: depend on actual network situation (more than 1500 ms)

Communication cable