5.2 HMI IP

5.2.1 IP settings

Introduction

This is for setting HMI IP (also PI HMI could support DHCP mode). When enable DHCP mode, the setting is invalid.

There are system-special addresses for them, the detailed information of addresses, please refer to the help document.

✒️ Note : HMI setup screen could select WIFI or Ethernet mode.WIFI and Ethernet mode only can be swtiched by manual.IP setting function only can be enabled when HMI is ethernet mode.

Operating procedure

1) Open [Project setting] windows;

2) Open [HMI IP] sub-windows;

3) Check [HMI IP];

4) Enter parameters;

5) Click [OK] button to save setting and exit windows;

5.2.2 Remote access password

Introduction

[Remote access password] is for PI8000 & PI9000 series HMI, the password is for remote function, when users use WECON Smart APP on mobile or WECON Cloud website on PC, which could access HMI screen remotely, the APP or website will require this password.

Operating procedure

1) Open [Project setting] windows;

2) Open [HMI IP] sub-windows;

3) Enter password;

4) Click [OK] button to save setting and exit windows;